Stained Glass Workshop Security Tips
By [http://EzineArticles.com/expert/Leroy_Garner/549670]Leroy Garner
Whether you are a seasoned or new stained glass crafter or artisan, it is essential to think about well being in your stained glass workshop or studio. There are the obvious hazards of working around glass, but tools and chemicals can also be hazardous.
When you go to your stained glass supplier, do not bring small children. There is too big of a risk of being cut by glass and being exposed to toxic fumes, dust and lead. Most stained glass warehouses post signs requesting that small children don't enter areas where the glass is stored. Your local retail stained glass trader would appreciate not having the tension of having a "bull in a China shop."
When carrying sheets of stained glass, wear your mitts that help you have a good grip on the glass. The your gloves should safeguard your hands from cuts from the razor sharp edges of the glass. Grip the glass on each side. Carrying it with one hand on top and one on bottom creates a hazard that the glass could snap in two. If you grip from each side and the sheet of stained glass breaks, you have an improved prospect of letting the glass slip far from you without being cut.
When scoring and breaking glass at your workbench, wear protective eyewear and your mitts. Be cautious not to utilize your hand to swipe glass shards out of your way. Keep a bench brush and dust pan handy so that you can regularly disregard your workbench. This will reduce accidents and also keep a fine surface to work at. The tiniest glass shard under an article of stained glass that you are scoring can cause the piece you are working on to have an unwanted break.
Never use a glass grinder without protecting your eyes. Glass particles can fly up into your eyes and cause terrible pain and may permanently damage your eyes. Most glass grinders are equipped with face shields or face shields can be obtained individually.
While grinding your glass, wear goggles that shield your eyes from all sides to prevent glass particles from getting into your eyes from underneath since the grinder is below eye level. It would also be a good idea to wear a paper mask to avoid inhaling the glass particles and dust that may be harmful to your sinuses and lungs.
When leading the stained glass pieces, wear your mitts to look after you from exposure to lead poisoning. If you have cuts on your hands, cover them with band-aids. Pay cautious attention to your hot soldering iron. Do not look away and reach for your iron. You may grasp the wrong end of the iron... the end that is several hundred degrees hot!
Ensure that your area is well airy when you are soldering. Fumes from solder and flux contain harmful lead and acid. Solder scraps should be kept in a special container for taking to a recycler.
Occasionally new glass crafters do not have a workshop and think they are in a position to commence by working at their kitchen table or counter. That is a precise risk of exposing you and your loved ones to lead poisoning, chemical contamination, and hazards from the shards of stained glass. It would be better to established a space in your garage or an unused room. Some glass shops will permit you to rent bench time.
Everyday sense and a clean stained glass workshop will be of assistance keep you safe and augment your enjoyment of the skill of glass.
Leroy has been writing articles online for nearly 2 years now. Not only does this author specialize in weight loss, fitness and diet, you can as well check out his latest website on home standby generators [http://www.homestandbygeneratorsale.net/home-standby-generators.html] and girls sleeping bags [http://www.girlssleepingbags.net/].
Article Source: [http://EzineArticles.com/?Stained-Glass-Workshop-Security-Tips&id=3709657] Stained Glass Workshop Security Tips