Stained Glass Scoring and Breaking - An Art in Itself
By [http://EzineArticles.com/expert/Edmond_Warren/553926]Edmond Warren Scoring and breaking stained glass is an art that you are able to achieve but not without some practice. All it takes is somewhat patience and you will soon be in a position to cut and break stained glass like a pro! The first thing to do when cutting glass is to relax when you are handling stained glass. It will make the task go more smoothly. Having the specific stained glass cutter is important. Various companies manufacture various types of glass cutters. They have cutting wheels of either carbide or steel. The wheel size and honing angles vary for the purpose in specific types of glass cutting. If you would like the correct cutter for stained glass, it is best to go to a glass supplier. Cutters in hardware stores are by and large made specifically for cutting clear glass. Carbide wheels be even more but last longer than steel wheels. They'll eventually get dull or even nicked and have to be replaced; but, you can exchange the wheel only and not have to get a whole new cutter. Stained glass cutters must be lubricated to hold the wheels rolling freely. Most stained glass cutters, like Toyo or Fletcher pistol grip and pencil grip cutters, have a reservoir for oil which runs down a wick to the cutting wheel. Stained glass cutters incorporate different addresses which make the choice one of preference and fit. Once you have picked out your favorite cutters, it is better not to let others use your cutter. They'll put pressure on it differently than you which changes the balance. Pencil grip glass cutters have a ball on one end which is accustomed to tap the stained glass underneath the score line to begin a running break so that the glass can be pulled apart. Stained glass that has been scored can be pulled apart by hand; but often times, the glass pieces are too small to grip. Glass pliers can be familiar with separate the pieces that are too small to grasp. Special "running" pliers are made for breaking straight furrows. Some glass pliers have smooth gripping surfaces. Others have teeth for scraping off rough edges or shards of glass. Gripping one side of the glass firmly with your thumb along one side of the score gives the glass some stability. The breakers are utilized on the opposite side, pointing toward the score. You use a quick pulling away and down motion. If your score is long, it is best to "rock" your pliers at one end to commence a running break; then do the same at the opposite end of the score, then pull the glass apart. A good score is drained one continuous motion. Starts and ends will only cause a bad score line which will wind up in an awful break. Going over a score line twice dulls your glass cutter and makes a bad score line. Put up with up when scoring glass so that you can put on even pressure using the weight of your arm and leave your wrist free to follow curves. A metal ruler can be employed to assist in cutting straight furrows. Be sure to grasp the glass cutter straight up and down. If your cutter is leaning to one side, it outcomes in a beveled cut, causing the stained glass pieces to fit poorly. Make sure you glass is clean before you cut it so that nothing interferes with a smooth score. Cut on the smooth side of the glass. Edmond has been writing articles online for nearly 5 years now. Not only does this author specialize in weight loss, fitness and diet, you can also check out his latest website on Low Voltage Outdoor Lighting [http://www.lowvoltageoutdoorlightingreview.com/] and Concept 2 Rowing Machine [http://www.indoorrowingmachine.net/concept-2-rowing-machine.html] Article Source: [http://EzineArticles.com/?Stained-Glass-Scoring-and-Breaking---An-Art-in-Itself&id=3732837] Stained Glass Scoring and Breaking - An Art in Itself
0 Comments
Leave a Reply. |
AuthorTHE POSSIBILITIES OF STAINED GLASS ARE ENDLESS, IT'S MY TRUE PASSION. Archives
July 2019
|